 鲜花( 6)  鸡蛋( 0)
|
本帖最后由 craigliu 于 2011-3-13 12:10 编辑
2 B/ s8 w$ J4 E" B _3 O6 A5 ?9 c6 t. |6 W5 {+ [) a" u$ t/ P
"打算把这个硬盘拆下来连到另一台电脑上,可是怎么才能连上呢?". ( g2 o4 Q$ d% m- ^
1) Open case, you usually need to open two sides.
s. \8 n3 h T! r# s! c! [2) unplug cables that attached to the HD. Usually there are two cables (one for power, one for data).' K. u% ]% g! c
3) unscrew for HD.+ F- X, Z N# I: H, d" N" X( S6 T
4) take out HD.
! {( s& j. E* X8 @6 ?5) Usually The HD is set as Master, and you need to reset jumper pin into Slave. There is a label on the HD that indicators how you set jumper pin. . V. i: j( ?: p! z
6) open the case of another computer.$ ~& Q! M ]/ @
7) Connect all cables. (two cables. Only correct cable can be plugged. So just try, if you can plug in, it is right cable.)
$ \7 D* g1 Y. w5 ]8 f8) start computer.1 v2 c/ t+ _8 f: V( \
5 E2 I7 S8 W8 G$ _$ H) n
(I suppose you use the HD that was popular before, because you use XP.) |
|