 鲜花( 7)  鸡蛋( 0)
|
How to avoid too much chips left in panel box after your drill a hole ?8 Q1 K5 W' {) J% g# |" i' G9 U5 C
8 y" W! @2 V5 U/ t& {4 p
1. If you are going to drill a hole on top of a box, use some paper to cover the bottom of the box so that you can easily remove the paper with chips in it;
2 R% {+ u5 v) O1 Y) O+ T2. Make sure you cover all equipments (breakers, contacts, relays, fuses, Etc)in the box before you drill holes;
/ [0 j- \( L5 V9 P- f0 n3. Use a paint brush to collect all debris (one of the best tools that is always in my tool box), and clean it up before your get all connectors in;
0 l; f) c1 i/ i4. Use your level's magnetic side to collect all steel chips;# s& P3 o+ R2 ^) l# I9 e
5. Use duct tape to get rid of all small chips;
4 R" i# W) ]4 }9 \5 J5 d1 n6. Use a vacuum if you just have it beside you(a bit too luxury, but why not!)., g3 r- a1 a, }
2 e* ~& I7 `9 I5 [& X. n; r
And another vital important point: DO NOT try to below those chips out! Most likely you will just below your mess everywhere, including your precious eyes. _- |# ~0 j0 e! Q, X' r
* t! D4 Q$ B1 P# c' \
+ v0 E" s( R4 SDonate a flower if your think this article is helpful. Welcome all reply, and add some of your secret!
7 l2 K/ i( @/ `9 Y- X# w
! g0 U0 q/ ]7 B) U$ f `' E[ 本帖最后由 homestay 于 2009-3-14 19:32 编辑 ] |
|