 鲜花( 0)  鸡蛋( 0)
|
this is what code says:
5 F. _: o+ b- i* ~- ^' g/ \& a4-028: Identification of insulated neutral conductors up to and including No. 2 AWG2 S3 |/ C# S, x, Z
copper or aluminum
: s& [- O$ O: ^# x# ~% O(1) Except as permitted in Subrules (2), (3), and (4), all insulated neutral conductors up to and including$ f4 t! X( \8 W7 O/ c% y8 `; _3 w
No. 2 AWG copper or aluminum, and the conductors of flexible cords that are permanently connected to* x0 I2 C% I' B* F5 f( D% Q5 Z
such neutral conductors, shall be identified by a white or grey covering or by three continuous white stripes
% T! @- B: G0 F( S( m" d. i- g+ Yalong the entire length of the conductor.6 x8 y3 v% l; j9 H
(2) Where conductors of different systems are installed in the same raceway, box, or other type of enclosure+ r& W6 K/ W$ F) W; [& t
and the identified circuit conductor of one system is coloured by a white or grey covering, each identified
0 g" k5 B; }* Icircuit conductor of the other system, if present, shall be provided with a specific identification, and the9 i3 b8 B; d# [3 N/ {7 E! E
identification shall be permitted to be an outer covering of white with an identifiable coloured stripe (not
# z5 \: J* e; G+ n/ Ggreen) running along the insulation.
& {' d8 t9 {* P/ x; d0 n$ Q(3) The covering of the other conductor or conductors shall show a continuous colour contrasting that of
& w$ C) @- q# f) Han identified conductor; however, in the case of those flexible cords where the identified conductor is
" {; q( d0 l0 @/ b& @2 b, pidentified by a raised longitudinal ridge(s), the other conductors shall have no ridges.
; ~$ h M; J# J( w(4) For multi-conductor cable, the insulated neutral conductor shall be permitted to be permanently marked
5 n5 \( X2 `' w$ _: E. Yas the identified conductor by painting or other suitable means at every point where the separate
9 v$ u. _( ]! k1 ]' {2 \7 Jconductors have been rendered accessible and visible by removal of the outer covering of the cable, and
7 ?7 e3 c! M) \& Dthe painting or other suitable means of marking the identified conductor shall not be permitted to render4 ^3 ~, ~. y2 v- M" L
illegible the manufacturer’s numbering of the conductor. |
|