 鲜花( 7)  鸡蛋( 0)
|
How to avoid too much chips left in panel box after your drill a hole ?! V' ], m. Z$ P: V
0 l: E) I9 W# I2 t' g) i1. If you are going to drill a hole on top of a box, use some paper to cover the bottom of the box so that you can easily remove the paper with chips in it; ) B( C t5 Q9 C- r, T
2. Make sure you cover all equipments (breakers, contacts, relays, fuses, Etc)in the box before you drill holes;) |" g4 w7 m) O& s6 P
3. Use a paint brush to collect all debris (one of the best tools that is always in my tool box), and clean it up before your get all connectors in;
0 L) |0 B* H0 c& `7 h/ P4. Use your level's magnetic side to collect all steel chips;9 T* F/ V, e; s
5. Use duct tape to get rid of all small chips;6 M. Z5 e. H% B6 _
6. Use a vacuum if you just have it beside you(a bit too luxury, but why not!).
& t' n" E- \5 h% B8 R+ A) ^5 V+ m: P H
And another vital important point: DO NOT try to below those chips out! Most likely you will just below your mess everywhere, including your precious eyes.
$ U) I0 u1 g: N% i1 O; `" T, h3 U, [: g- e
" o. D, x8 {$ Q, KDonate a flower if your think this article is helpful. Welcome all reply, and add some of your secret!3 A* c) p; s$ W7 e, r5 F& K; f2 m
$ r7 g9 J" A+ |3 h% \1 L& X' x) ]
[ 本帖最后由 homestay 于 2009-3-14 19:32 编辑 ] |
|